Free-Vend means your ArtVend coin mechanisms will turn without needing any coins. To do this you will need to remove a few parts from your coin mechanisms.
Recommended Supplies
- Screwdriver. We recommend THIS flexible ratcheting screwdriver for the hard to reach screws.
- Containers to separate screws
- Rag to clean off tools
- Lubricating grease for the gears if needed
Using the diagram below, you are going to want to remove all screws (6) except for the one in the middle left holding parts (12) and (13). Save screw part (10) for last. Slowly unscrew (10) and place to the side. Gently separate the back plate (4) from the front plate (2). Pull the coin wheel (3) off of the front plate (2). Remove the coin wheel (3), the coin detector (14), the coin detector spring (15), the washer detector spring (12), and the washer detector (13). Reverse your steps (this is best done with a partner).
Any linked products include an Affiliate link which we receive a commission for any purchases made.
Leave a comment (all fields required)